Product Introduction:
Basic performance: This machine can process a piece of glass at the same time. Cutting arms are installed on both sides of the vertical axis. The spacing and number of blades can be adjusted. Manual operation can meet the needs of cutting straight lines of various shapes and sizes.
Equipment and processing parameters:
Model
| Maximum cutting size
| Minimum cutting size
| Cutting thickness
| Diagonal cutting accuracy
| Cutting efficiency
| Cutting life of cutter wheel
|
800 | 650*650mm | 25*25mm | 0.5-6mm | ±0.20mm | 10s /piece | 30000-50000meters |
1310 | 1300*1000mm | 15*15mm | 1-12mm | 1-2min/piece |
Scope of application: Offline cutting of flat glass, ultra-thin glass, glass mosaic, TOF, LCD glass, microcrystalline glass, and amorphous silicon glass
|
2. Cutting parameters:
Cutting accuracy: ± 0.20mm/m (manual adjustment is required for accuracy and accurate glass positioning)
Diagonal accuracy: ±0.25mm/m (manual adjustment is required for accuracy and accurate glass positioning)
Cutting life of single blade wheel: 20000-30000m
3. Instructions for use
(1) Blade box adjustment
Place a small piece of glass under the blade wheel, loosen the limit screw nut on the top of the blade box, rotate the limit screw so that the lower end of the blade box is at an angle of 60°-75° with the glass surface, then tighten the limit screw and the nut. In addition, the cutting pressure can be adjusted by rotating the knurled nut on the bottom of the blade box.
(2) Adjustment of cutting size
First, adjust the first positioning knife box, loosen the knife box locking block bolt, and align the pointer on the knife box with the scale line to be locked by the steel ruler; in the same way, adjust the second knife box according to the required cutting size and conduct a test cut; after passing the test, adjust the third knife box according to the above method, and adjust the cutting size of the following knife boxes in the same way.
