Product Introduction:
Basic performance: The machine can automatically load and manually cut, realizing simultaneous processing of a piece of glass. Cutting arms are installed on both sides of the vertical axis, and the spacing and number of blades can be adjusted. Manual operation can meet the needs of cutting straight lines of various shapes and sizes.
Equipment and processing parameters:
1. Equipment parameters
model
| 2620 | 3826 | 4228 | 5133 | 6133 | power
| Can be customized according to cutting size
|
Maximum cutting size | 2500*1900mm | 3700*2500mm | 4100*2700mm | 5000*3200mm | 6000*3200mm | 380V/50HZ |
Workbench height：900±50mm |
Application: architectural glass, automotive glass, craft glass, wafer glass, decorative glass, cabinet glass, coated glass, home appliance glass, solar glass, furniture glass, bathroom glass, lens, craft glass, mirror glass and other glass cutting operations
|
2. Cutting parameters:
Cutting accuracy: ± 0.20mm/m (needs manual adjustment and accurate glass positioning)
Diagonal accuracy: ±0.25mm/m (needs manual adjustment and accurate glass positioning)
Minimum size of glass after cutting: 20*20mm
Cutting life of single blade wheel: 20000-30000m
3. Product parameters:
Loading device:
Circulating sprocket chain: high-precision reinforced wear-resistant type
Vacuum suction cup: butyl rubber material (double adsorption structure)
Circulating reducer: Chuangyan (Sino-German joint venture)
Suction cup lifting reducer: Chuangyan (Sino-German joint venture)
Vacuum pump: Xinsihai
Fastest loading cycle: 15-40 seconds (adjustable)
Number of single-side loading arms: 2-3
Number of single-arm suction cups: 3-4
Compressed air: 0.6-0.8kpa
Vacuum pressure: -50~70Kpa (adjustable according to glass thickness)
4. Cutting instructions
(1) Knife box adjustment
Place a small piece of glass under the knife wheel, loosen the limit screw nut on the top of the knife box, rotate the limit screw so that the swing block at the bottom of the knife box forms an angle of 60°-75° with the glass surface, then tighten the limit screw and the nut. The cutting pressure can also be adjusted by rotating the knurled nut at the bottom of the knife box.
(2) Cutting size adjustment
First adjust the first positioning knife box, loosen the knife box locking block bolt, and align the pointer on the knife box with the scale line to be locked by the steel ruler; in the same way, adjust the second knife box according to the required cutting size and conduct a trial cut; after passing the test, adjust the third knife box according to the above method, and adjust the cutting size of the following knife boxes in the same way.
